Using Ipega 9023 on Recalbox

Today, I tried to connect my new Ipega 9023 to Recalbox installed on a Raspberry Pi 3. It happen that it is not so easy. Here are the steps to perform.

Connect to your Raspberry with SSH with root account (default password is recalboxroot). Remount file system with write access :

mount -o remount,rw /

Add the following line to /etc/udev/rules.d/99-joysticks-exotics.rules :

SUBSYSTEM=="input", ATTRS{name}=="ipega Extending Game controller", MODE="0666", ENV{ID_INPUT_JOYSTICK}="1"

The exact name of your gamepad can be found after pairing, using the dmesg command. So you may be able to use this method with any other.

And set the following value in /recalbox/share/system/recalbox.conf :

global.inputdriver=sdl2

Reboot. Done.

2 Replies to “Using Ipega 9023 on Recalbox”

  1. gracias
    pg 9083

    SUBSYSTEM==”input”, ATTRS{name}==”PG-9083″, MODE=”0666″, ENV{ID_INPUT_JOYSTICK}=”1″

  2. Thank you very very very much! I am using an Ípega PG-9078 and it worked perfectly. I used WINSCP to connect on Raspberry via SSH.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.